Normal Procedure Checklist

avatar
Created by
Clark Robuza

Cards (5)

  • CLIMB CHECK
    1. Mixture - CONFIRM FULL RICH
    2. Pitch Attitude - AS REQUIRED
    3. Throttle - FULL


    4. Engine Gauges - Within GREEN RANGE
    5. Wing Flaps (400 ft AGL) - CRUISE


    6. Airspeed - 75 KIAS or AS REQUIRED
    7. Trim - ADJUST
    8. Engine Cowling - CLEAN
  • CRUISE CHECK
    1. Fuel Pump - OFF or AS REQUIRED
    2. Throttle - AS REQUIRED
    3. Mixture - AS REQUIRED


    4. Wing Flaps - CONFIRM RETRACTED TO CRUISE


    5. Trim - AS REQUIRED
    6. Engine Gauges - CHECK
    7. Carbon Monoxide Card - CHECK
    8. Landing Lights - AS REQUIRED
  • BEFORE LANDING CHECK
    1. Seat Belts - FASTENED & SECURE
    2. Lights - AS REQUIRED
    3. GEN/BAT Master Switch - CONFIRM ON
    4. Ignition Switch - CONFIRM ON BOTH
    5. * Fuel Pump - CHECK ON
    6. * Mixture - CONFIRM FULL RICH
    7. * Engine Gauges - CHECK

    APPROACH
    8. * Speed Check - BELOW 100 KIAS
    9. * Flaps - EXTEND to TAKEOFF
    10. * Trim - AS REQUIRED
    11. * Speed Check - BELOW 78 KIAS
    12. * Flaps - EXTEND to LANDING
    13. * Approach Speed - 55-60 KIAS
  • AFTER LANDING CHECK
    1. ATC Clearance - AS REQUIRED
    2. Throttle - AS REQUIRED
    3. Runway - TAXI CLEAR

    Do not stop on the taxiway unless instructed by ATC or for safety.

    4. Once on the apron - STOP and complete items 5. through 11.
    5. Transponder - CONFIRM ‘STANDBY’ Mode
    6. Mixture - FULL RICH
    7. Time - RECORD
    8. Wing Flaps - RETRACT TO CRUISE
    9. Strobe Lights - OFF
    10. Other Lights - AS REQUIRED
    11. Aircraft - TAXI AS REQUIRED
  • ENGINE SHUTDOWN & SECURING AIRCRAFT
    1. Parking Brake - SET
    2. Throttle - IDLE
    3. Fuel Pump - OFF
    4. ELT - CHECK 121.5 (IF REQUIRED)
    5. Live Magneto Check - L-R-OFF-R-L-BOTH (WITH MINIMAL DELAY)
    6. Mixture - IDLE-CUT-OFF
    7. Ignition Switch - OFF and REMOVE KEY
    8. Avionics Master Switch - OFF
    9. Electric Consumers (except.nav lights) - OFF
    10. Navigation Lights. - ON
    11. GEN/BAT Master Switch - OFF

    12. Hobbs Meter - RECORD
    13. Parking Brake - RELEASE IF REQUIRED
    14. Wheel Chocks, Control Locks and Tie Downs - AS REQUIRED