metalwork lathe

• Setting up the centre lathe

  • Ensure the power is off
  • Load the material securely into the chuck, using the chuck key and make sure to remove it before turning the lathe on
  • Place the correct tool into the tool post
  • Make sure the tool is set at the correct height
  • Make sure the speed is set correctly for the material and process you are using
  • Place the guard down into position
  • Test the stop and emergency stop buttons
• parallel & step turning - used to reduce the diameter of the metal along it's length

  
• taper turning - produces a conical shape on the metal

  
• facing off - used to level the end of a piece of metal

  
• parting off - used to remove or part pieces of metal on the lathe

  
• knurling - produces a diamond pattern with provides grip

  
• drilling:

  • A centre drill is used to create a small hole in the centre of the metal workpiece
  • A twist drill bit is then used to create a hole to the correct size & depth, using the centre hole as guidance