Contractor

• In a sleeping room what Is the maximum height of a window sill measured from the top of the finished floor to the top of the window still

  44”
• Working scaffold platforms should be kept at what maximum distance from a wall being plastered and lathed

  18”
• If installing board and batten siding, how is the batten attached

  Nailed into the stud or substrate below only
• If using screws or pins to attach a non-load bearing steel stud to a concrete floor, what is the maximum distance from each end of the track for a fastener

  2”
• When is type lll cement used

  During cold weather when early strength is needed
• Which of the following cannot be used for eye protection

  Regular glasses with thick plastic frames
• Type X Sheetrock has a rating that is based on 


  Fire resistance
• How is the width of a door jamb determined

  from the outside of outer wall to inside of inner wall
• What is the actual size of a finished 2 x 6

  1 1/2“ X 5 1/2“
• What is the correct moisture barrier under a concrete floor

  6mil lapped 6”
• Which of the following would be the correct way to frame a 5’ x 5’ stair opening through a floor

  Double the header and trimmer joists
• A week or so after concrete is placed a powdery substance appears on the surface indicating

  Overworking the concrete when placing
• All exterior concrete footings must be placed at what distance below undisturbed ground surface and below the frostline

  12”
• If joining two studs to make a box connection how much of an overlap do you provide

  6”
• Which of the following statements about vibratory settlement of concrete is correct

  A stiffer batch may be used
• What type soil is used for backfilling a basement wall


  Same as soil is used for footer
• How far from the block should the level string be located when placing a masonry wall

  1/16”
• What is the minimum distance from finished grade to the top of the concrete footing for a wood framed house

  8”
• What is first done when installing base cabinets in a kitchen

  find floor high spots
• What is the minimum slope on which metal tiles can be applied to a roof

  December 30,1899 3:12:00 AM -0500
• What is the actual dimension of a 2 x 4

  1 1/2 x 3 1/2
• When working in a trench or a hole without water protection what is the maximum amount of water allowed to collect in the bottom

  0”
• The backseat for a door lock is centered how far back from the edge of the door

  2 3/8”
• Batter boards are required to be placed how far from the edge of the footer

  4”