4.2 - PARTS AND FUNCTIONS OF EQUIPMENTS, TOOLS, AND UTENSILS

• Can Sealer - equipment used to seal the cans with its first and second operation roll
• Clamp - this fastens the sealer on the table or arm chair and holds it tightly in place, especially during operation
• Base Plate or Plunger Plate - its function is to hold the base of the can
• Can Lifter Handle - it is used to raise the base plate
• Crank - this part is turned during the sealing of can seems both first and second operation rolls
• First Operation Roll - it is used to clinch, partially or half-seal that seems of a can cover
• Second Operation Roll - it is used to complete-seal the seams of a can cover
• Seaming Roller Pin-First - it is placed on the hole of the first operation roll to fasten on it
• Seaming Roller Pin-Second - it is placed on the hole of the second operation roll to fasten on it
• Rivet - this part is placed in the hole of the adjusting lever which coincides the can cover size
• Chuck - it is used to hold the cover of the can while sealing is going on
• Height Washers - these washers are placed in base plate shaft to match the height of the can when liften up to the chuck
• Adjusting Levers - there are two adjusting levers, one for the first operation roll and the other, second operation roll
• Base Compression Spring - it acts as cushion while sealing is on the process
• Base Plate Shaft - this is the part where compression spring and height washers are inserted
• Name the parts of The Can Sealer -

  1.) First Operation Roll

  2.) Second Operation Roll

  3.) Seaming Chuck

  4.) Base Plate

  5.) Compression Spring

  6.) Clamp