Assessment

Cards (25)

  • What do you call an extension of the Microsoft Management Console that allows full management of the disk-based hardware recognized by windows?
    Disk Management
  • What makes a partition the drive C:?
    It is the first patition created
  • What do you call a the part of a computer system that is mechanical and can be touched?
    Hardware
  • What do you call a set of rules governing communication within and between computers on a network?
    Internet Protocol
  • What do you call the memory that stores the applications and programs that run on the PC, as well as any work created by users?
    HDD
  • Which is the main part of a computer system that is also called a chasis?
    System Unit
  • Which is referred to as the engine or "brain" of a computer?
    Processor
  • It is a configuration program that allows you access and configure your BIOS hardware settings.
    BIOS setup utility
  • It is a way to setup a computer system or the assortment of components that make up the system.
    Configuration
  • If you will rufus to create a bootable device, which storage device should you use?
    USB Flashdrive
  • What commands is used to test the ability of the source computer to reach a specified destination computer?
    ping
  • What tool is used to drive or fasten positive slotted screw?
    Philips Srewdriver
  • What do you call a 40-pin male connector that is used to interface disk drive?
    IDE
  • A computer network used for communication among computers and different information technological devices close to one peraon?
    PAN
  • What computer hardware component installed in the system unit that connects a computer network with the use of a LAN cable?
    Network Interface Card
  • Which is referred to as devices or media used to store data or programs for future use by a computer?
    Storage Devices
  • Which motherboard component that contains all information and settings of the motherboard in the form of a chip?
    BIOS
  • What ethernet cable is used in connecting a peer-to-peer network?
    Cross-over cable
  • What do you call an approach to computer networking where all computers show equivalent responsibility for processing data?
    Peer to peer
  • Which of the following is an example of class B subnet mask?
    255.255.0.0
  • What tool is used to test and verify the network cable connection are correct and will work for the intended purposes?
    LAN tester
  • Which of the following is a number used to identify a device on a network?
    IP Address
  • What do we call an electronic device that accepts and processes data to produce information that can be stores for future use?
    Computer
  • Which of the following IP address classes does 192.168.10.10 belongs?
    Class C
  • What particular microcomputer is intended for regular use at a single location desk/table due to its size and power requirements?
    Desktop Computer